Crankshaft 47mm stroke \/ 100mm conrod Stage6 R\/T 100FL for Malossi C-One \/ RC-One crankcase

Stage6 R\/T high-end crankshaftCrankshaft 47mm stroke \/ 100mm connecting rod Stage6 R\/T 100FL for Malossi C-One \/ RC-One cases, latest development of the Stage6 R\/T Team. The crankshaft can be mounted with the Malossi C-One or RC-One cases!

The high-end racing crankshaft was clearly designed for racing and to get the maximum power out of the Stage6 RT FLR 100cc cylinder .

As a central part of the engine, the crankshaft is an essential element for the stability of an engine, but above all for the optimal power transmission of the engine and resulting power and torque.

Stage6 R\/T tuning crankshaftIn contrast to conventional crankshafts, the lower crank pin of the Stage6 R\/T shaft was dimensioned to 20mm. The bearing on the lower connecting rod eye was chosen correspondingly larger. This leads to the fact that the pressing of the cheeks is much stiffer and the entire crankshaft is much more durable. At peak powers over 40PS and especially in circuit use, a must have (Bigger is simply better here).
Of course, special attention was also paid to the design and balancing of the crankshaft, especially in view of the use with the RT100cc cylinder.

The crankshaft is manufactured in Italy with the highest quality standards:

high-end balancing using six high-density Tungsten inserts (17.6 g \/ cm3) and ultra-light connecting rod (less than 80 g)noticeable power increase in both low as well as high rpm rangeall Stage6 R\/T crankshafts are controlled for oscillation within max 0,02mm to maximally reduce vibrationshot forged shafts made of case hardened 18 Ni Cr Mo5 steelthread rolling by cold forming (not cutting) for increased durabilityheat treatments with controlled HRC (hardness) on shafts and axlesdouble hardening cycle for the connecting rod, also with controlled hardnessCNC-machined connecting rod with final quality check of hole parallelismperfect surface finish by grinding and lapping for better reliability with 100% dimensional stabilityHQ small end bearing, silver plated, designed for high speedsAll crankshafts are coated with a heavy layer of oil for protection. They should be thoroughly cleaned with fuel before assembly.

TECHNICAL DETAILS FOR STAGE6 R\/T crankshaft 100FL:High end crankshaftCrankpin 20mm x 41mmStroke 47mmConnecting rod 100mm (12 to 14mm piston pin depending on bearing)Diameter crank webs: 79mmWeight: 1,8kg